This article will provide the steps on how to pair your Ingenico iSMP4 to your iOS device.
Power
- The device should be fully charged prior to use if it will be used in a mobile environment.
- Only the included USB-C cable can be used to charge the device as no other cable is compatible.
- The device can be powered on by holding the power button on the upper right side for several seconds until you hear a series of beeps and text begins to appear.
- The device is powered off by holding the power button for several seconds.
- The device can be rebooted by holding the Yellow and .,#* buttons for several seconds.
Note: If the device is plugged into power, it will turn on automatically.
Pairing the Device (iOS Device Steps)
- Ensure the iOS device is powered on and charged or charging.
- Open the iOS Settings app
- Select Bluetooth
Pairing the Device (iSMP4 Steps)
- Power the device on.
- You will see either “BT Pairing Required” or “Lane Closed.”
- If you see “BT Pairing Required,” press the F1 Key under iOS and go to Step 6.
- If you see “Lane Closed” tap the F key five times in quick succession.
- You should now see “BT Pairing Required,” press the F1 Key under iOS.
- Use the F1 through F4 keys as arrow keys until you locate the iOS device by its name.
- The iOS device name can be found at the device in the Settings app > General > About or in the Bluetooth Menu as “Now discoverable as _____.”
- When you locate the device, highlight it, and press the green key.
- The iSMP4 will now display a PIN.
- On the iPad, you will be prompted to enter this PIN.
- The device may appear on the iPad as a “Cordless Phone” initially.
- The device may appear on the iPad as a “Cordless Phone” initially.
- The device should now read as paired on both devices.
- Tap F1 on the iSMP4 to Save.
- The device will reboot and it is now paired.
- If you see a screen that says “Not Paired” tap F3 for Change Settings and attempt the pairing procedure again.
