To view the status of an Ethernet connection, use the following steps:
- Press the two buttons at the bottom right underside of the terminal screen simultaneously (or hold the power button down for 2-3 seconds).
- A control panel screen will appear asking for the password to the device (password is 1elo).
- After entering the password, the home screen will load. This will show if the device is connected to the network.
- At the bottom of the screen, select 'Network' and then choose the LAN tab to view the connection.
Configure Static IP
To setup a static IP on the Ethernet connection, use the following steps:
- Press the two buttons at the bottom right underside of the terminal screen simultaneously (or hold the power button down for 2-3 seconds).
- A control panel screen will appear asking for the password to the device (password is 1elo).
- Select 'Apps' at the bottom of the screen and then 'Settings.'
- Choose 'Ethernet Configuration' and then Ethernet Configuration' again.
- Tap Static IP and enter the IP Address, Netmask, and Gateway Address.
Disable WiFi
If the device is using Ethernet/LAN only, we recommend disabling the WiFi to avoid network conflicts.
- Press the two buttons at the bottom right underside of the terminal screen simultaneously (or hold the power button down for 2-3 seconds).
- A control panel screen will appear asking for the password to the device (password is 1elo).
- Select 'Apps' at the bottom of the screen and then 'Settings.'
- Toggle the WiFi from 'On' (blue) to 'Off' (gray) to disable.